Wireless Mode

This mode uses the 2.4GHz frequency band for data transmission and relies on radio frequency (RF) technology, which connects to the computer via a USB receiver and allows the scanner to move freely within a certain distance.

Wireless Mode Default

Note

Receivers are divided into small receivers and base receivers

One-to-One Pairing

One-to-One Pairing

Note

It works in the following situations: pull out the receiver, scan the pairing code on it, and the scanner will make a continuous beeping sound. At this time, re-insert the receiver, and the sound will stop immediately, indicating that the pairing is successful.
This operation is required in the following situations:
① Plug the 2.4G receiver into the USB port. After scanning successfully, it will beep three times but will not upload data.
② Requires pairing with a new receiver.

Receiver Keyboard Transmission Speed[1]

Get Receiver Keyboard Transmission Speed[2]

High Speed

High Speed

Medium Speed

Medium Speed

Low Speed

Low Speed

---

[1]

Only applicable to RF Dongle with FWVerL and above versions. Note that the speed of the scanner and the receiver must match, otherwise errors may occur when transmitting long barcodes.

[2]

It is only valid in wireless 2.4G mode and when the receiving end is receiving normally.